Owner manual

3. Run selftest of ISP connector in PG4UW (Programmer / Selftest ISP connector…).
Diagnostic POD for ISP connectors #2 is used for testing 20 pins ISP connector of
programmers. Diagnostic POD for ISP connector #2 is available as standard accessory for
866C, 866B and 859. The order number: 70-0680.
Schematics of Diagnostic POD for ISP connectors #2 (if you are in hurry):
Sequence for testing 20 pins ISP connector:
1. Insert Diagnostic POD for ISP connectors #2 into ZIF socket of the programmer.
Diagnostic POD for ISP connectors #2 must be inserted as 48 pins device.
2. Interconnect 20 pins connector of Diagnostic POD for ISP connectors #2 with an ISP
connector of the programmer with an ISP cable, included in delivery programmer
package. Be sure that pins are interconnected properly (i.e. 1-1, 2-2, ..., 20-20).
3. Run selftest of ISP connector in PG4UW (Programmer / Selftest ISP connector…).
We recommend run this test every 6 months.
Programmer / Calibration test
Command executes test of programmer's calibration values using 48 Pins Calibration test
POD, Type I, which is optional accessories for 866C, 866B and 859. The order number: 70-
0438.
There are tested voltage levels of TTL drivers, VCCP, VPP1 and VPP2 voltages on each pin
of ZIF socket. Result of the Calibration Test can be saved into file and/or printed (for next
use).
Options
The Options menu contains commands that let you view and change various default settings.
100