User`s manual

Power supply connector

Note: Due to low power consumption of 848 in inactive state, it

doesn't require power switch.

Connecting 848 programmer to PC

Switch off the PC and programmer. Insert the connection

cable, included in the 848 programmer delivery, to the free

printer port of PC. If your computer is equipped with only one

printer port, substitute the programmer cable for the printer

cable. Connect the opposite cable end to the programmer.

Screw on both connectors to counter connectors. This is very

important mainly for the connector to programmer. Though

replacing the printer cable by the programmer cable is

uncomfortable, it is not recommended to operate the 848

programmer through a mechanical printer switch. Use of an

electronic printer switch isn't possible.

Connect the mains connector of the power supply (or wall-plug

power supply self) to a mains plug, connect the connector to

the programmer's connector labeled 12VDC. Then, on the

programmer lights up LED POWER and the programmer 848

is ready to run. Next switch on the PC and run the control

program.

Caution! If you don't want to switch off your PC when

connecting the 848, proceed as follows:

• When connecting the programmer to the PC: FIRST insert

the communications cable and THEN the power-supply

connector.

• When disconnecting the programmer from the PC: FIRST

disconnect the power-supply connector and THEN the

communication cable.

Problems related to the 848



interconnection, and their removing

If you have any problems with 848  PC interconnection,

see section Common notes please.

Manipulation with the programmed

device

After selection of desired device for your work, you can insert

into the open ZIF socket (the lever is up) and close socket (the