User`s manual

• pindriver: 40 TTL pindrivers, universal GND/VCC/VPP

pindriver

• FPGA based TTL driver provides H, L, CLK, pull-up, pull-

down on all pindriver pins, level H selectable from 1.8 V up to

• in-circuit serial programming (ISP) capability included

• continuity test: each pin is tested before every programming

operation

ISP connector

• 10-pin male type with missinsertion lock

• 6 TTL pindrivers, provides H, L, CLK, pull-up, pull-down; level

H selectable from 1.8V up to 5V to handle all (low-voltage

including) devices.

• 1x VCCP voltage (range 2V..7V/100mA) and 1x VPP voltage

(range 2V..25V/50mA)

• programmed chip voltage (VCCP) with both source/sink

capability and voltage sense

DEVICE SUPPORT

Programmer, in ZIF socket

• EPROM: NMOS/CMOS, 27xxx and 27Cxxx series, with 8/16

bit data width, full support of LV series (*1*2)

• EEPROM: NMOS/CMOS, 28xxx, 28Cxxx, 27EExxx series,

with 8/16 bit data width, full support of LV series (*1*2)

• Flash EPROM: 28Fxxx, 29Cxxx, 29Fxxx, 29BVxxx, 29LVxxx,

29Wxxx, 49Fxxx series, with 8/16 bit data width, full support

of LV series (*1*2)

• Serial E(E)PROM: 24Cxxx, 24Fxxx, 25Cxxx, 45Dxxx,

59Cxxx, 25Fxxx, 25Pxxx, 85xxx, 93Cxxx, full support for LV

series (*1)

• Configuration (EE)PROM: XCFxxx, 37LVxx, XC17xxxx,

EPCxxx, AT17xxx, LV series including

• NV RAM: Dallas DSxxx, SGS/Inmos MKxxx, SIMTEK

STKxxx, XICOR 2xxx, ZMD U63x series

• PLD: series: Atmel, AMD-Vantis, Cypress, ICT, Lattice, NS,

... (*1)

• microcontrollers 51 series: 87Cxxx, 87LVxx, 89Cxxx, 89Sxxx,

89LVxxx, LPC series from Atmel, Atmel W&M, Intel, Philips,

SST, Winbond (*1*2)

• microcontrollers Atmel AVR: ATtiny, AT90Sxxx, ATmega

series (*1*2)

• Microcontrollers Cypress: CY8Cxxxxx

• Microcontrollers ELAN: EM78Pxxx

• Microcontrollers EM Microelectronic: 4 and 8 bit series

• microcontrollers Microchip PICmicro: PIC10xxx, PIC12xxx,

PIC16xxx, PIC17Cxxx, PIC18xxx, dsPIC series, 8-40 pins

(*1*2)

• microcontrollers Scenix (Ubicom): SXxxx series