User`s manual

Problems related to the 864



interconnection, and their removing

If you have any problems with 864  PC interconnection,

see section Common notes please.

Manipulation with the programmed

device

After selection of desired device for your work, you can insert

into the open ZIF socket (the lever is up) and close socket (the

lever is down). The correct orientation of the programmed

device in ZIF socket is shown on the picture near ZIF socket

on the programmer's cover. The programmed device is

necessary to insert into the socket also to remove from the

socket when LED BUSY light off.

Note: Programmer's protection electronics protect the target

device and the programmer itself against either short or long-

term power failures and, partly, also against a PC failure.

However, it is not possible to grant the integrity of the target

device due to incorrect, user-selected programming

parameters. Target device may be not destroyed by forced

interruption of the control program (reset or switch-off PC), by

removing the physical connection to the programmer, but the

content of actually programmed cell may remains undefined.

Don't unplug the target device from the ZIF socket during work

with devices (LED BUSY shine).

Self test and Calibration

If you feel that your programmer does not react according to

your expectation, please run the programmer self test using

Diagnostic POD, enclosed with the standard delivery package.

For optimal results with programmer we recommend you

undertake every 6 months, an extended test and to check the

calibration. See instructions for self test in the Diagnostics

menu of PG4UW.