User`s manual

HARDWARE

Base unit, DACs

• FPGA based IEEE 1284 slave printer port, up to 1MB/s

transfer rate

• on-board powerful microprocessor (20MHz) supported by

FPGA based state machine, 20MHz powered

• three D/A converters for VCCP, VPP1, and VPP2,

controllable rise and fall time

• VCCP range 0..8V/1A

• VPP1, VPP2 range 0..26V/1A

• auto calibration

• self test capability

• protection against surge and ESD on power supply input,

parallel port connection

• banana jack for ESD wrist straps

Socket, pindriver

• pin drivers: 48 as standard max. 256

• 1x VCC, 2x VPP can be connected to each pin

• perfect ground for each pin

• FPGA based TTL driver provides H, L, CLK, pull-up, pull-

down on all pindriver pins

• analog pindriver output level selectable from 1.8 V up to 26V

• current limitation, over current shutdown, power failure

shutdown

• ESD protection on each pin of socket (IEC1000-4-2: 15kV air,

8kV contact)

• continuity test: each pin is tested before every programming

operation

Socket, base configuration

• 48-pin DIL ZIF (Zero Insertion Force) socket accepts both

300/600 mil devices up to 48-pin

DEVICE SUPPORT

865 with DIL48 socket module

• EPROM: NMOS/CMOS, 2708*, 27xxx and 27Cxxx series,

with 8/16 bit data width, full support for LV series

• EEPROM: NMOS/CMOS, 28xxx, 28Cxxx, 27EExxx series,

with 8/16 bit data width

• Flash EPROM: 28Fxxx, 29Cxxx, 29Fxxx, 29BVxxx, 29LVxxx,

29Wxxx, 49Fxxx series, from 256Kbit to 32Mbit, with 8/16 bit

data width, full support for LV series