User`s manual

Manipulation with the programmed

device

After selection of desired device for your work, you can insert

into the open ZIF socket (the lever is up) and close socket (the

lever is down). The correct orientation of the programmed

device in ZIF socket is shown on the picture near ZIF socket

on the programmer's cover. The programmed device is

necessary to insert into the socket also to remove from the

socket when LED BUSY light off.

Note: Programmer's protection electronics protect the target

device and the programmer itself against either short or long-

term power failures and, partly, also against a PC failure.

However, it is not possible to grant the integrity of the target

device due to incorrect, user-selected programming

parameters. Target device may be not destroyed by forced

interruption of the control program (reset or switch-off PC), by

removing the physical connection to the programmer, but the

content of actually programmed cell may remains undefined.

Don't unplug the target device from the ZIF socket during work

with devices (LED BUSY shine).

In-system serial programming by

865

For ISP programming by 865 is necessary change DIL48

socket module by ISP module.

ISP module attached to 865 programmer is manual operated

ISP programming solution, suitable for development and

low/middle volume production application.

Optimized advanced pindriver deliver programming

performance without overshoot or ground bounce for all device

technologies. Pin drivers operate down to 1.8V so you'll be

ready to program the full range of today's advanced low-

voltage devices.

The ISP programming solution performs programming

verification at the marginal level of supply voltage, which,

obviously, improves programming yield, and guarantees long

data retention.

The ISP programming solution provide also the power supply

for the target system.