User`s manual

In Pins with capacitors bar may be entered a list of a pins
interconnected by capacitors (for example: if a converter,
which have connected capacitor between VCC and GND, is
used), which may makes problems at detecting insertion of a
new device.
List of pins of device is in form:
pinA, pinB, pinC....
Example: 4,6,17
In Device removal hold off time is possible to set a time
within the program will not insertion of new device into the
programmer's ZIF socket after a (old) device was removed
successfully. This interval is in seconds and must be from 1 to
120 (default value is 2 seconds).
In Device insertion complete time is possible to set a time
within all pins of the device have to be properly inserted after a
first pin(s) detected so that the program will not detects
incorrectly inserted device. This interval is in seconds and
must be from 1 to 120 (default value is 5 seconds).
This list is erased if a new device is selected by Device /
Select default or Device / Select device ...
This setting is saved to disk by command Options / Save
options.
Programmer / Selftest
Command executes a selftest of current programmer without
diagnostic POD. We recommend execute also Programmer /
Selftest plus of programmer.
Programmer / Selftest plus
Command executes a selftest of current programmer using
diagnostic POD, which is included in standard delivery of
programmer. We recommend run this test every 6 months.
Programmer / Self test ISP connector
Command executes a selftest of ISP connector of current
programmer using diagnostic POD for ISP connectors.
Diagnostic POD for ISP connectors is necessary to use for
testing 6 and 10-pin ISP connectors of programmers.
Diagnostic POD for ISP available as optional accessory for
ISP-capable programmers. The order number: 70-0208
Schematic of Diagnostic POD for ISP connector (if you are in
hurry):
140