User`s manual

Note: Items Establish communication and Speed are available
only for 848.
Port - selects a LPT port, which will be scanned for a
requested programmer. If All port is selected, the control
program scans all LPT ports, which are available on standard
addresses.
Address for special port - sets address of LPT port, if a
Special port is selected.
Pressing key <Enter> or button OK initiates scanning for
programmer by set parameters. There is same activity as at
start the control program. The command clears a list of default
devices without the current device, if the new selected
programmer supports this one.
This setting is saved to disk by command Options / Save
options.
Programmer / Refind programmer
This menu command is used to refind (reestablish
communication with) currently selected programmer.
To select other type of programmer, programmer
communication parameters and to establish communication
with newly selected programmer use menu Programmer /
Find programmer.
Programmer / Handler
In dialog Handler a Handler type and Handler communication
parameters can be set. Handler is an external device for
special control of device operations in control program. When
None Handler is selected, this means default state of control
program, i.e. device operations are controlled directly by user
otherwise control program is in special mode, when device
operations are controlled automatically with co-operation with
Handler.
Dialog Handler contains following items:
Selected Handler select wished Handler type.
Search at port select a COM port, which will be scanned
for a requested Handler.
Pressing key <Enter> or button OK initiates scanning for
Handler by set parameters. If selected Handler type is None,
no Handler scanning will be processed. Current Handler
settings are saved to configuration file by command Options /
Save options or when control program is closed.
138