User`s manual

Installing programmer hardware

• switch off the PC and programmer

• connect the communication port of programmer to a printer

port of PC using cable supplied

• switch on the PC

• connect the connector of the power supply adapter to the

programmer

Installing the programmer software

Run the installation program from the CD (Setup.exe) and

follow the on-screen instructions. Please, for latest information

about the programmer hardware and software see

www.bkprecision.com .

Using programmer software

Launch PG4UW.exe to enter the control program. The menu

Device contains the device manipulation commands. The

menu File contains commands for files and directories. The

menu Buffer is to be used for buffer manipulation.

Programming a device - the shortest way

Use the hot key <Alt+F5> to input the device name and/or

manufacturer to select the desired type of target device. If you

want to copy an existing device, insert it into the ZIF socket of

the programmer and then press key <F7>. If you want to

program a target device with data from a disk press key <F3>

and read the appropriate file into the buffer. Then insert your

target device into the ZIF socket. To check if the device is

blank - press key <F6>. Now you can program the device by

pressing key <F9>. After programming you may perform

additional verification by pressing key <F8>.