User`s manual

Buffer / Fill block
Selecting this command causes filling selected block of buffer
by requested hex (or ASCII) string. Sets start and end block for
filling and requested hex or ASCII string.
Buffer / Copy block
This command is used to copy specified block of data in
current buffer on new address. Target address needn't be out
from source block addresses.
Buffer / Move block
This command is used to move specified block of data in
current buffer on new address. Target address needn't be out
from source block addresses. Source address block (or part)
will be filled by topical blank character.
Buffer / Swap block
This command swaps a high- and low- order of byte pairs in
current buffer block. This block must start on even address and
must have an even number of bytes. If this conditions do not
fulfill, the program modifies addresses itself (start address is
moved on lower even address and/or end address is moved on
higher odd address).
Buffer / Erase
If this command is selected, the content of the buffer will be
filled with topical blank character.
The reserved key <Ctrl+F2> will bring out this menu from any
menu and any time.
Buffer / Fill random data
If this command is selected, the content of the buffer will be
filled with random data.
The reserved key <Shift+Ctrl+F2> will bring out this menu from
any menu and any time.
Buffer / Duplicate buffer
This command performs duplicate buffer content in range of
source EPROM to range of destination EPROM. This
procedure is suitable if there is used for example 27C512
EPROM to 27C256 EPROM position.
Note: The procedure always uses buffer start address 00000h.
111