User`s manual

Buffer / View/Edit
This command is used to view (view mode) or edit (edit mode)
data in buffer (for viewing in DUMP mode only). Use arrow
keys for select the object for edit. Edited data are signified by
color.
You can use <F4> hot key also.
View/Edit Buffer
F1 display help of actual window
F2 fill block causes filling selected block of
buffer by requested hex (or ASCII) string.
Sets start and end block for filling and
requested hex or ASCII string.
Ctrl+F2 erase buffer with specified blank value
Ctrl+Shift+F2 fill buffer with random data
F3 copy block is used to copy specified
block of data in current buffer on new
address. Target address needn't be out
from source block addresses.
F4 move block is used to move specified
block of data in current buffer on new
address. Target address needn't be out
from source block addresses. Source
address block (or part) will be filled by
topical blank character.
F5 swap bytes command swaps a high- and
low- order of byte pairs in current buffer
block. This block must start on even
address and must have an even number
of bytes. If this conditions do not fulfill,
the program modifies addresses itself
(start address is moved on lower even
address and/or end address is moved on
higher odd address).
F6 print buffer
F7 find string (max. length 16 ASCII
characters)
F8 find and replace string (max. 16 ASCII
chars.)
F9 change current address
F10 change mode view / edit
F11 switch the mode of buffer data view
between 8 bit and 16 bit view. It can be
also doing by mouse clicking on the
button to the right of View/Edit mode
buffer indicator. This button indicates
actual data view mode (8 bit or 16 bit),
too.
108