User manual

Menu Operation

Follow the following steps to manually configure the LAN

interface:

 Set the IP Address. Contact your network administrator

for the IP address to use. All IP addresses take the

dot-notation form “nnn.nnn.nnn.nnn” where “nnn” in each

case is a byte value in the range 0 through 255. Move the

cursor to the IP address position and change the IP

address using the entry knob.

 Set the Subnet Mask. The subnet mask is required if

your network has been divided into subnets. Move the

cursor to the subnet mask position and enter the subnet

mask in the IP address format using the entry knob.

 Set the Gateway IP. The gateway address is the

address of a gateway which is a device that connects two