User Manual

Quick Start Guide
194
6.5 PASS/FAIL Measurement
The oscilloscope measures and compares the input signal
with predefined Pass/Fail thresholds. If the input signal is
within the thresholds, PASS signal will be outputted. If the
input signal exceeds the thresholds, FAIL signal will be
outputted.
Perform the following steps to make a PASS/FAIL
measurement.
 Press UTILITY key to display the UTILITY menu page
1/2.
 Press More 1/2 softkey to display the UTILITY menu
page 2/2.
 Press Pass/Fail softkey to display the PASS/FAIL menu.
 Press Enable Test softkey to turn on the PASS/FAIL
measurement.
 Press Setup Mask softkey to display the MASK menu.
 Press X Mask softkey and then rotate the entry knob to
setup the horizontal threshold.
 Press Y Mask softkey and then rotate the entry knob to
setup the vertical threshold.
 Press Creat Mask softkey to update the thresholds.
 Press softkey to return to the PASS/FAIL menu.