Instruction manual

13. CH2 VOLTS/DIV control. Adjusts the vertical sensitivity for channel 2 in fixed amounts.
14. CH2 INPUT JACK. Not needed in this lab.
15. Horizontal TIME/DIV control. Adjusts the rate, in discreet steps, at which the electron
beam is swept across the screen.
16. HORIZONTAL POSITION control. Adjusts the horizontal position of the trace.
17. AUTO button.
19. External Trigger. The connector at which an external trigger signal is fed into the scope.
Not used in this lab.
Figure 4:
4 Using The BK Oscilloscope
In this section the BK scope is used to examine various AC voltages. You will be able to
“see” how the voltage depends on time, measure the amplitude at various times, and measure
times between different points on the voltage vs time curve. It will probably be helpful to
refer to previous sections during these exercises.
6