User manual

20
Note: Any value programmed above or below the valid range of the instrument would not be
accepted and would be reported as error.
Command Syntax: [SOUR:]VOLT[:LEV][:IMM][:AMP] <Nrf>
Parameters: 0 to 270 | MAX | MIN
Unit: V (Volts)
Examples: VOLT<sp>230; VOLT:LEV<sp>230; VOLT:AMP<sp>120
VOLT<sp>23.22;
VOLT<sp>230.12;
VOLT<sp>230.1;
Query Syntax: [SOUR:]VOLT[:LEV][:IMM][:AMP]?
Returned Parameters: <NR2>V
Related Commands: None.
[SOUR:]FREQ[:CW |: IMM] <NRF+>
This command sets the frequency in Hz as per the instrument model and the range limits.
Note: Any value programmed above or below the valid range of the instrument would not be
accepted and would be reported as error.
Command Syntax: [SOUR:]FREQ[:CW |: IMM] <NRF+>
Parameters: 45 to 450 | MAX | MIN
Unit: Hz (Hertz).
Examples: FREQ<sp>120; FREQ:CW<sp>100; SOUR:FREQ:CW:IMM<sp>50
FREQ<sp>50.22;
Query Syntax: [SOUR:]FREQ[:CW |: IMM]?
Returned Parameters: <NR2>Hz
[SOUR:]VOLT:RANG <NRf+>
This command sets the voltage range of the ac source. Two voltage ranges are available: a 135 volt
range and a 270 volt range. Sending a parameter greater than 135 selects the 270 volt range,
otherwise the 135 volt range is selected. When the range is set to 135, the maximum rms voltage that
can be programmed for a sine wave is 135 volts. Any value greater than the 270 volt range would
indicate an DATA OUT OF RANGE error accordingly.
Command Syntax: [SOUR:]VOLT:RANG <NRf+>
Parameters: 135 | 270 | MAX | MIN
*RST Value: 270
Examples: VOLT:RANG<sp>270; VOLT:RANG<sp>MIN
Query Syntax: [SOUR:]VOLT:RANG?
Returned Parameters: <NR2>V
Related Commands: VOLT, SYST:CONFIG
CAUTION: ALWAYS DISCONNECT THE LOAD ON THE OUTPUT TERMINALS BEFORE
CHANGING THE RANGE.
MEASUREMENT SUBSYSTEM
MEAS:[SCAL:]VOLT:AC?
This query returns the AC rms voltage being sourced at the output terminals.
Query Syntax: MEAS:[SCAL:]VOLT:AC?
Parameters: None
Unit: V (Volts).
Examples: MEAS:SCAL:VOLT:AC?;
MEAS:VOLT:AC?
Returned Parameters: <NR2>V