User manual

15
V A RANGE
Hz W REM/LOC
2. Use the rotary knob to adjust the digit selected by the cursor, which by
default will appear under the least significant digit of the voltage parameter
on display.
3. To change cursor position, press the rotary knob. This only works while the
unit is in Voltage Set mode and cursor is shown on the display.
4. Once you set to the voltage you want, press V-SET button again to exit
Voltage Set mode or leave the unit idle for 10 seconds and it will
automatically exit out of Voltage Set mode.
Setting Output Frequency
To set the frequency for the output, follow the steps below:
1. Press FREQ-SET button on the front panel to go into Frequency Set mode.
The display should look like the figure below.
V A RANGE
10.0 0.05 HI
50.00 1 LOC
Hz W REM/LOC
2. Use the rotary knob to adjust the digit selected by the cursor, which by
default will appear under the least significant digit of the voltage parameter
on display.
3. To change cursor position, press the rotary knob. This only works while the
unit is in Frequency Set mode and cursor is shown on the display.
4. Once you set to the voltage you want, press FREQ-SET button again to
exit Frequency Set mode or leave the unit idle for 10 seconds and it will
automatically exit out of Frequency Set mode.
10.0 0.05 HI
50.0 1 LOC