User manual

There is a small delay that follows to set the output voltage to the last set value

(Approx. 3 to 5 Seconds). After the output voltage gets stabilized, users can then

set the voltage and/or frequency to their desired values.

NOTE: Allow sufficient OFF time (Minimum 2 Minutes) before turning ON

again if the output is TRIP’ed by abnormal condition (Over temperature

and Over load).

3.4 OPERATING INSTRUCTIONS IN LOCAL MODE

3.4.1 Setting Voltage and Frequency

Setting Output Voltage

To set the voltage for the output, follow the steps below:

1. Press V-SET button on the front panel to go into Voltage Set mode. The

display should look like the figure below.

V A RANGE

10.0 HI

60.0 LOC

Hz W REM/LOC

V A RANGE

0.0 0.00 LOW

60.0 0.00 LOC

Hz W REM/LOC

After 1 second