User manual

The world of flow
Seite 9
The battery is accessible from the back of the
instrument.
There is a vertical notch under the middle of
the nameplate.
Cut through the nameplate there.
Then slide out the two-part battery cover to
one side along the guide grooves, and replace
the battery observing the correct polarity.
The instrument should not be connected to
24 VDC at this time!
1
2
3
4
5
6
0 V
Modell 260
IG
"LOW"-aktiv
Programmier-
Masse
Eingang A
Zähleingang B
Rückstelleingang
eingang
24 VDC Eingang
für Backlight
24 VDC
"LOW"-aktiv
"HIGH"-aktiv
IG
"HIGH"- aktive Sensoren
"HIGH"-aktiv
Zähleingang B bei "LOW"-aktiv Programmierung (Kontakt nicht dargestellt)
The world of flow
Seite 10
5. Programming
The instrument can only be programmed by setting the
programming input PROG to 0 V.
Please note that this causes the pulse counter to be reset
internally.
After having set the programming input PROG to 0 V, the
following is displayed:
This display identifies the rate meter (Channel A); it cannot
be changed.
By repeatedly pressing the S/E key, you can cycle through
the individual menu items. The following figures correspond
to the factory settings of the instrument:
Physical unit, Accuracy,
Channel A Channel A
Sensor pulse constant, Scaling factor,
Channel A Channel A