User guide

14 |
Software setup | Zeus Installation Manual
Software setup
The Zeus requires some initial con guration before use, in order to get the most out of the
product.
The following sections focus on settings that typically will not require change once
con gured. User preference settings and operation are covered in the operator manual.
Pressing the home key brings up the home page, which has three distinct panels.
The scrollable left column of icons access most settings that require con guration;
First time startup
When the Zeus is started for the  rst time, or after a factory default, the unit will raise
prompts requesting the user to select some fundamental setup options;
Choose language.
Initiate source selection for data sources both internal and external to device.
Check all external data sources and NMEA 2000 data bus are turned on.
Simulation uses recorded data to allow product demonstration of features otherwise not
possible without physical installation on a vessel.