Instruction Manual

32
SPEED DATA SOURCE SELECTION
This SETUP parameter is used to select the source of the speed data
used in the autopilots calculations.
SPD TRA Speed data from a Speed Sensor supplied via the system
network cables from a Network SPEED or QUAD. This is
the usual setting for most systems and is the factory
setting.
SPD SOG Speed data via the NMEA interface from a
position fixer.
SPD MAN Manual speed band selection.
Press SETUP key, to
display SPD.
Press ENTER key, the
display will flash.
Use the ÙÙ or ÚÚ keys to
cycle through the
options.
Press ENTER key to
memorise the new SPD
setup.