User Manual

31
EDITING A STORED ROUTE
Any stored route in the route library can be edited.
Waypoints can be inserted into or deleted from any leg of
your defined route, or simply added on to the end. There is
also facility to delete the entire route from the route library. If
all the waypoints are deleted the route will be listed as nOt
USEd
when the route library is viewed.
To edit a leg of a route proceed as follows:
INSERTING AND DELETING WAYPOINTS IN A ROUTE
1. Press the ROUTE key until ROUTE # is displayed.
Select the route to be edited from the route library with
the
▼ STEP ▲
knob.
2. Press the
SETUP
key and turn the
▼ STEP ▲
knob to
list the route leg by leg.
3. When the leg to be edited is displayed press the
ENTER
key.
4. The waypoint name or number will now flash.
5. Turn the ▼ STEP ▲ knob until the word INSERT or
DELETE is displayed.
6. Press the enter key to INSERT or DELETE a waypoint.
7. If DELETE has been selected the displayed waypoint is
immediately deleted, so you must be sure! The number
of legs will now have decreased by one.
8. If INSERT has been selected the ▼ STEP ▲ k nob
allows the waypoint library to be listed (see DEFINING
A ROUTE). Press the ENTER key to select the
waypoint to be inserted. The number of legs will now
have increased by one.
ADDING WAYPOINTS TO THE END OF A ROUTE
1. Press the ROUTE key until ROUTE # is displayed.
Select the route to be edited from the route library with
the
▼ STEP ▲
knob. Press the
SETUP
key.
2. Turn the
▼ STEP ▲
knob until
END
is shown on the
right of the text display.
3. Press the ENTER key, END will now flash.
4. Turn the ▼ STEP ▲ knob to cycle through the waypoint
library until the desired waypoint is displayed.
5. Press the
ENTER
key to select the displayed waypoint.
END
will continue to flash, allowing more waypoints to
be added if required.
6. Press the ENTER key again to end route editing.
DELETING ROUTES FROM THE ROUTE LIBRARY
1. Press the ROUTE key until ROUTE # is displayed.
2. Press the SETUP key twice. The display will show
ERASE, and ROUTE #. The route number will flash.
3. Turn the ▼ STEP ▲ knob to cycle through the route
library until the desired route is displayed.
4. Press the
ENTER
key, the display will flash YES.
5. Turn the
▼ STEP ▲
knob to change the display to NO if
you change your mind.
6. Press the ENTER key when YES is displayed to delete
the route. A DELETED ROUTE CANNOT BE UN-
DELETED.