User guide

NETWORK COMPASS USER MANUAL

COMPASS DISPLAY UNIT

PORT

CRSE 1

STEER

MODE

TIMER LOCK SETUP LIGHTS

ENTER

Network COMPASS

30 20 10 302010

OFFCOURSE

EXAMPLE SYSTEMS USING NETWORK COMPASS

Up to four COMPASS units can be connected to the system. Only one of these should be

linked to a fluxgate and set to transducer mode, the others must be set to repeater mode.

Refer to SELECTING THE DISPLAY MODE to see how to change modes.

In this configuration the main unit controls all the measurement parameters such as

offset and damping. These parameters can be changed via the keyboard on any of the

units: repeaters will send appropriate network messages to the main unit so that it can

keep its parameters up to date.