Specifications

___________________________________________________H3000 Pilot Handbook
HB-3001-02
55
Parameters to be Set
The following is a list of the parameters that have to be set during
commissioning.
These parameters must be set and configured prior to using the Autopilot.
Parameter
Page
No.
Boat Type: Select Sail, Power Planning or, Power
Displacement
56
Compass Swing: Compass deviation correction 31
Heading Source: Compass data selection 35
Heading Offset: Compass alignment correction 31
Magnetic DIP angle compensation: 68
Rudder drive type selection 57
Rudder end stop Port position 57
Rudder end stop Starboard position 58
Rudder Mid position 58
Rudder hard over time 58
Speed sensor calibration 69
Boat waterline length in meters 70
Boat Lag value 64
Rudder Gain value 62
Watch alarm lock – Disables alarm ON/OF control 71