User Manual

h2000 Autopilot User Manual
Part 4 - Installation Information
HB-0842-04
4-1
PART 4 - INSTALLATION INFORMATION
CONTENTS
Para Page
4.1 CABLE AND CONNECTION INFORMATION 4-3
4.1.1 EMC Compliance 4-3
4.1.2 General Wiring Notes 4-3
4.1.3 Autopilot Drive Unit Cables 4-4
4.1.4 ACP Unit Terminal Details 4-5
4.1.5 Clutch Voltage Selection 4-6
4.1.6 Dip Switch Location 4-7
4.2 ACP WIRING CONNECTIONS 4-8
4.2.1 Network and Alarm Connections 4-8
4.2.2 Autopilot Display Connections 4-9
4.2.3 MOB, Joystick, Hand-held Controller
Connections 4-10
4.2.4 Hydraulic Ram Drive Connections 4-11
4.2.5 Continuous Drive Connections 4-12
4.2.6 Direct Speed Input Connections 4-13
4.2.7 Linear Feedback Connections 4-14
4.2.8 Gyro Stabilised Compass Connections 4-15
4.3 ROTARY RUDDER REFERENCE
SENSOR (RRF) 4-16
4.3.1 Installation of RRF 4-16
4.4 LINEAR FEED BACK UNIT 4-19
4.4.1 Linear Feedback Unit 4-19
4.5 RUDDER DRIVE UNIT 4-20
4.5.1 Description 4-20
4.5.2 Sterndrive Unit Connections 4-21
4.5.3 Rotary Drive Connections 4-22
4.5.4 Proportional Solenoid Connections 4-23
4.6 USING A NON-B&G SPEED SENSOR 4-24