Owner's manual

h2000 User Manual
88 HB-0845-06
8. Press Enter to store the new value into the
system.
9. Press Page to return to full display.
3.2.7 Speed Calibration Referenced to a Known
Value
To calibrate the Boat Speed by reference to a known value,
e.g. another boat with an accurately calibrated log, proceed
as follows:
1. Select BOAT SPD KT on upper half of FFD
display:
2. Press Scroll Down until the lower text shows
CALBRATE flashing.
3. Press Enter, the lower text now shows AUTO
CAL flashing.
4. Press Scroll Down until the lower text shows
REF CAL flashing.
5. Press Enter, the lower text now shows REF CAL
along with the current value of Boat Speed.
6. Press Enter, the lower text now shows the REF
CAL value flashing and by use of the Scroll
Up/Down the reference speed may be adjusted to
the new value.
7. Press Enter, the new speed value is accepted and
the upper display will show the re-calibrated Boat
Speed.
3.2.8 Boat Speed Units (Knots, MPH, KPH)
To configure the required boat speed units proceed as
follows:
1. Press Scroll Up until the upper text shows LOG
flashing.