Owner's manual

HB-0845-06 45
2.7 LIGHTING CONTROL
The level of illumination at system displays is controlled by
the Power Lights Key. Use of this key normally controls all
the h2000 displays simultaneously. However, the level of
illumination on a single FFD can be controlled individually
under the menu choice - LIGHTING →
→→
→ LOCAL.
2.7.1 Select Local Lighting Control
1. Press and hold Scroll Up or Scroll Down until
LIGHTING appears in the text.
2. Press Enter and use Scroll Up or Scroll Down
until LOCAL appears in the text.
3. Press Enter again and the original page display
appears. The FFD is now in local mode.
The Power Lights Key now controls this display only. This
will enable you to use very low lighting at the chart table
down below, whilst retaining the brightness up on deck.
2.7.2 System Lighting Control
1. Select LIGHTING.
2. Press Enter and use Scroll Up or Scroll Down to
select SYSTEM.
3. Press Enter again, the original page display
appears and the lighting has returned to system
control.
The Performance Unit has an input that allows the display
lighting to be controlled externally. This can be used to
switch the h2000 lighting ON and OFF.
The lighting brightness is still controlled by successive short
presses of the lower right hand key on an FFD in the normal
way. Displays which have their lighting control set to
LOCAL will not be affected by the lighting control input.