Owner's manual

HB-0845-06 195
nnn = number of node from which value is to be obtained.
1 - Depth Board
5 to 8 - Wind Board
9 to 12 - RS232 or NMEA Board
13 to 16 - Expansion Boards
17 to 18 - Pilot Boards
255 - Broadcast to all Boards
mmm = message type to be used
211 - Calibration Value 1
212 - Calibration Value 2
213 - Calibration Value 3
214 - Calibration Value 4
206 - Damping Value
34 - High Alarm Value
33 - Low Alarm Value
32 - Sector Alarm Value
1 - Data Value
fff = function number of value to be sent
This is a general purpose command for getting values from
any node (including the Performance Unit itself) and replies
with the value as follows:
Vnnn,mmm,fff,xx.xx(CR)
xx.xx = value
5.15.33 NMEA Sentence Output Rate Selection
#NS,p,fff,r(CR)
can be used to set the output rate of a specified NMEA
sentence, where:
p is the NMEA port number, 1 or 2
fff is the three-character NMEA sentence formatter
r is the desired output rate in Hz
Example: