Specifications

h1000 pilot
installation
Page 17
installation
precautions
To avoid electromagnetic interference, it is
recommended that the Pilot display be installed
no less than 0.3 metres from a compass and 1
metre from a GPS.
The Pilot is water resistant, but not waterproof.
Use the cover when not in use. The rear
connectors that are not connected to cables
must remain protected by their appropriate
caps.
panel mounting
Ensure there is sufficient room behind the panel to accommodate the fixings and connections, and
using the template supplied, cut a hole in the panel in the desired position.
Fix the mounting bracket into the hole using the screws supplied.
Note: The sealing ring is fitted to the unit during manufacture. Its purpose is to prevent moisture
penetration and reduce the effects of any vibration transmitted through the instrument panel.
Press the Pilot Display firmly into the mounting bracket; an audible ‘click’ will indicate that the
case is correctly located.
Secure the unit to the instrument panel by fitting the studs and thumbnuts supplied.
Caution: To avoid damaging the casing, fixing studs must only be tightened ‘finger-tight’.
Mounting
Bracket
Sealing Ring
(Fitted at Manufacture)
Pilot Display
Unit
Protective
Cover