Specifications

calibration
h1000 pilot
Page 16
calibration
Note: For full details of calibrations for your h1000 pilot refer to the Installation
Manual supplied with your unit.
Calibration
Calibration values take time and effort to
set up and it is often necessary to perform
various manoeuvres with the boat. For this
reason, an optional security check is
provided before entry into the calibration
menus to save accidental resets. Refer to
the h1000 Pilot Installation Manual for full
details covering Compass, Dockside and
Sea trial calibrations.
entering secure mode
This feature is optional and can be disabled.
The security check uses a four digit Personal Identification Number or PIN. If security has been
activated, this PIN must be entered every time to access the Calibrations menu.
After a factory reset the PIN is set to 0000 and in this condition security checking is disabled.
Security is an option on the Calibrations menu, which allows a new PIN to be set. Once a non-zero
PIN has been set the security checking is enabled, and all subsequent access to the Calibration
menu is restricted.
Note: Once the PIN has been entered for any given session the PIN entry screen is
automatically by-passed when re-entering the calibration menu. Upon cycling the power,
the PIN is once again required to enter the calibration menu.
Security
disabled
Security
enabled