Owner`s manual

getting started
cnd
Page 8
switching on and off
Before turning the CND on, check that the
installation instructions in Appendix B have
been correctly followed.
Switching On
Pressing the
PWR
key for one second switches
on the
CND
, you will first be presented with the
B&G logo screen and software version
information.
The CND will then perform a short self test
procedure that checks internal memory and
displays any failure detected on the screen.
If installed, the C-CARD will also be tested.
After a few seconds, a Caution page is
displayed, reminding you that the chart plotter
is only an aid to navigation, and should be used
in co njunctio n with nor mal na vi gati ona l
practices.
Pressing any key will then display the
cartographic screen with a position if an
external GPS is connected.
The display can be customised for your
personal preferences using the System
Settings section.
Switching Off
Press the
PWR
key and hold for three seconds,
a countdown timer appears on the screen,
when this reaches zero it will power off.
If you release the key before the countdown
timer reaches zero, the CND will remain on.
backlight
There are three levels of backlighting. To alter
the level of backlighting, press and release the
PWR
key until the desired level.