Owner`s manual

appendix c
cnd
Page 54
terms and functions
Deleting MOB
To cancel the MOB mode, press and hold the
‘MARK’ key for two seconds.
Names
Turns On/Off the displayi ng of the local area
names.
The default setting is On.
Nav-Aids
Turns On/Off the Buoys and Beacons.
The default setting is On.
NMEA-0183
The NMEA-0183 Data Interface Standard was
developed by the National Marine Electronics
Association of America. It is an international
standard that enables equipment from many
different manufactures to be connected
together and to share information.
Output Format
Disables (Off) or sets the interface among
0183, 0180, 0180/CDX. The default setting is
0183.
Plotter Mode
Selects whether areas not covered by the
electronic charts on the C-CARD can be
viewed. If set to On, then the user can zoom in
to view Marks, routes, tracks and boat’s
position anywhere in the world down to a zoom
level of 0.008 Nm (Screen width = 15 metres),
regardless of what charts are on the C-CARD.
If set to O ff the n the
CND
will only displa y the
areas covered by the chart. When the edge of
chart coverage is reached, the CND will
automatically zoom out to the next available
smaller scale chart.
The default setti ng is Off.
Plotter Setup
(menu)
Enables/Disables the Plotter Mode and the
Position Correction, selects the desired value
for Position Offset, GPS Datum, Chart Datum.
Press the
CLR
key to return to the p revious
menu.
Port By Name
To locate and display the port inserting the
name.
The icon list of the available services is shown
on the screen.