Owner`s manual

appendix b
cnd
Page 46
installation
Precautions
To avoid electromagnetic interference, it is
recommended that the CND be installed no
less than 0.3 metres from a compass and 1
metre from the GPS.
The
CND
is water resistant, but not wa terproof.
Use the cover when not in use. The C-MAP
Cover must be properly closed and only
opened to i nsert or remove cartridges. In either
situation, this process must be performed in a
totally dry environment. The rear connectors
that are not co nnected to cables must remain
protected by their appropriate caps.
Panel mounting
Screw the bolts supplied into the fittings on the
back of the CND. A hole must be cut in the
panel usi ng the template supplied. Fit the CND
into the hole yo u have cut a nd place the
mounting bracket so that the panel is
sandwiched between it and the
CND
. Fit the
knobs onto the bolts and tighten.
The rubber sealing gasket should be placed
between the plotter and bulkhead to prevent
moisture penetration and reduce the effects of
any vibration transmitted through the
instrument panel.
electrical connections
Electrical Connection
Connec tions o n the back of the
CND
NMEA – Data from non B&G instruments.
Power/Data – Data from GPS antenna.
Fastnet
2
– Connects CND to h1000 system.
FastNet 2
Power/Data