Owner`s manual

cnd
settings
Page 35
setup menu
Selecting Alarms
Use the
CURSOR
keypad to scroll to the
Alarms menu and pressing the
ENTER
key to
select.
Use the
CURSOR
keypad to enable the alarm,
then use the
CURSOR
keypad to select and
change the value of a setting, and press the
ENTER
key to set.
When an alarm is activated the
CND
emits a
beep and a pop-up window is opened.
Anchor Drag Alarm
Triggers when the boat exits from the anchor
circle. The radius is set i n the Alarm Value.
HDOP Alarm
This specifies the minimum quality of satellite
signal to receive an accurate position fix. The
higher the value, the less accurate the fix.
Above the set number, the alarm sounds.
Cross Track Alarm
This specifies the distance perpendicula r to the
rhumb line, exceeding this value triggers the
alarm.
Waypoint Arrival Alarm
Specifies the radius of a circle around the
Waypoint/Mark of a route. When your boat
reaches this circle the alarm sounds.