Owner`s manual

cnd
getting started
Page 11
navigating on a route
If you prefer to navigate following a route
towards its end point, you can define a series
of locations (Waypoints) in sequence to make a
route.
Adding a Waypoint
Using the
CURSOR
keypad place the cursor
on the desired position, pressing the
ENTER
key will insert a Waypoint symbol on the chart,
press the ADD TO ROUTE Softkey to make it
the first point on your route .
Viewing Information on Waypoints
Position the cursor on the Waypoint and the
Cursor information box will change to the
Waypoint information box displaying the
Waypoint name and Latitude/Longitude.
Note:
Waypoints may be added by uploading
data from a PC, refer to Page 27 – Advanced
Features – Uploading waypoints from a PC.
Creating a route
Repeat the “Adding a Waypoint” procedure as
shown above until you reach your final
destination. The lines connecting the
Waypoints are known as a leg, a circle
surrounding the first Wa ypoint of the route
identifies the starting point.
Deleting a waypoint
Using the
CURSOR
keypad place the cursor
on the Waypoint to be deleted and press the
DELETE Softkey, a window opens to advise
that the Waypoint is being used in a route,
press the ACCEPT Softkey to delete it, the
Waypoint is deleted and a new line betwee n
previous and next Waypoint is shown.
Pressing the CANCEL Softkey returns to the
chart.