User manual

OPERATION MANUAL
Technical changes reserved
0141 0316-164 20.08.2015
Humidity- temperature probe
with USB-Interface
WINDOWS-Software RECORDER
With the help of this program, which is covered in the scope of supply,
the measured values can be received through the USB-interface and
recorded on the PC. The displayed le is compatible with any desired
spreadsheet program, with which it is possible to further process, stati-
stically evaluate or visualise the measurement data .
In addition, the PC-Software also calculates dew point, absolute hu-
midity, enthalpy and vapour pressure from the measured values of
relative humidity and temperature. The calculated gures can also be
stored .
System requirements
Windows 98, 2000, XP, Vista or WIndows 7 with RS232 or USB-in-
terface. Important tip: First connect the USB-Version to the PC after
installing the software. This simplies driver installation and enables
„Plug&Play“ feature.
Installation
A detailed installation instruction is provided on the CD, which automa-
tically gets started by inserting the CD (prerequisites: Internet-Explorer
5.0 or higher).
Manual Installation
Insert the enclosed CD into your drive and select „Run“ in the start-
menu and then browse to select the le ‚setup.exe‘ under the path E:\
software\RECORDER\TEMPLOG\disk1. Then follow the instructions
of the installation program.
First time operation
Connect the humidity measuring system to the USB-interface of a PC.
After the software runs the rst time, go to menu option „settings“ and
select device type as „HYTELOG 4800Bd“ and also select the COM-
Port. (Note: By USB-version, the COM-Port number under „interface“
will be specied during driver installation). The remaining settings
(Data rate, Parity, Start and Stop bit) are automatically selected and
need not be changed. If the connection is established, the data com-
munication appears on the terminal window.
Then select „OK“. The current settings will be stored.
If you are not able to establish data link between PC and the measuring
probe, then rst please check the USB cable connection to the PC.
Further information on debugging is available under FAQ´s on the CD
or at our Homepage under SUPPORT.
Data recording: First activate all the measurement channels for recor-
ding by checking the channels. In ‚Text 1‘ ,‚Text 2‘ and „Text 3“ you can
enter a description, as headed of the top of data le. The data is recor-
ded in a le, which is declared under „Settings -> path“. The recording
begins by pushing the ‚Start‘ button.
EXCEL™
The le will be recorded in CSV-Format. In order to display the measu-
red data, you can use graphic tools, for example, the diagram-assis-
tant. However, other programs such as Exel or OpenOfce can also be
used to graphically represent or evaluate the measured data.
Calibration
The measuring probe is supplied in calibrated condition. The accu-
racy at 23 °C is of ±0.3 °K and ±2 % RH. Under normal operating
conditions, it is not necessary to re-calibrate the probe. The cross
B+B Thermo-Technik GmbH | Heinrich-Hertz-Straße 4 | D-78166 Donaueschingen
Fon [phone] | Fax [phone] | [e-mail] | bb-sensors.com
2 / 3