Datasheet
DATA SHEET
Technical changes reserved
Mounting of measuring probes
Mounting should be done with the probe tube in downside direction to
avoid mearuring error caused by self heating of the electronic circuit.
Moderateowinregionoftheprobeisanadvantageconcerning
response time and accuracy.
Formountingofexternalmeasuringprobes,commerciallyavailable
bayonetconnectorsormountingangescanbeused.Pleaseaskfor
our accessories overview.
The probe is pressure tight up to 100 mbar. The probes are not suit-
able for compressed air with higher pressure.
For outdoor applications, a special weather protection housing with
mast/wallholderaswellasahydrophobicPEsinterlterisrecom-
mended.
The projected measuring probe type -INT can be directly mounted on
the ventilation ducts. Drill the holes with the help of enclosed drilling
template, for the probe and two mounting screws. Directly mount the
probe on the ventilation duct with a gasket in between. Alternatively, a
mountingangeisavailablewithclampingring/clampingscrews.
Drillingtemplateformeasuringamplier
Product variants
Type -INT
Themeasuringprobeisrmlyangedontotheevaluationelectronics.
Otherprobetubelengths(max.500mm)areavailableoninquiry.
Type -EXT
The measuring probe is connected to the evaluation electronics
throughasolidlymountedcable(approx.1.5minstretchedcondi-
tion). The length L
B
of standard model is around 100 mm. Probe tube
length 150 mm and 200 mm are available at short notice.
Other lengths or special models e.g. pressure resistant humidity
probe with ½“ mounting threads are available on enquiry.
Type -AF
Modelforwallmounting,forexample,asexternalprobe,themeasur-
ingprobeishorizontallyanged(atthefrontside)totheevaluation
electronics. Probe tube length is around 80 mm.
Humidity-Temperature probe with
standard Signal FF-GLT-Series
B+B Thermo-Technik GmbH | Heinrich-Hertz-Straße 4 | D-78166 Donaueschingen
Fon+4977183160|Fax+49771831650|info@bb-sensors.com|bb-sensors.com
3 / 7