Service manual

8.9 F9 –LOW VOLTAGE DETECTION

This parameter allows detection of low voltage when the battery wears down.

To enter this parameter, press the [Tare] key when “

F9 Ld M” is shown.

The display will show if the LVD Mode is set to on or oFF.

Press the [Func] key to scroll through the options.

Press [Tare] to accept the displayed value and return to the parameter or press the [Zero]

key to return to the parameter without changing the value.

Then press [Func] to advance to the first parameter.

Pressing [Zero] will display “

JP on” indicating the jumper is still in place. Switch off the

scale and remove the jumper.

NOTE : TO SECURE THE SCALE, IT IS NECESSARY TO REMOVE THE JUMPER AND

RE-SEAL THE SCALE.

NOTE: The scale has a special feature for displaying x10 the value of the weight which

is a useful tool during testing. Press the [1] key for more than 3 seconds. It will show

one extra decimal place making it a high resolution display. Pressing the [1] key again

for more than 3 seconds will bring the display back to the normal resolution.