Service manual

8.0 FACTORY PARAMETERS

The factory parameters are used performing the factory calibration, setting the capacity

and other basic settings.

To access these parameters place a jumper into the pins on the main PCB (marked as

position J4) through a hole provided on the base of the scale.

Turn the scale upside down.

Remove the seal covering the hole to access the PCB.

Place a jumper through the hole into the pins. If a

jumper is not available, short the pins.

Turn on the scale using the switch on the base.

“

P _ _ _ _”

Enter

“2006” and press [Tare]

After the jumper has been placed in the position shown, apply power to the scale.

The display will show the software revision number and then ask for a code number,

“P _ _ _ _ “.

Enter the number 2006 and press [Tare].

The display will show the first parameter “F1 CAL”. To scroll through other parameters

press the [Func] key.