User`s manual

71
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/write. If
your IDE hard drive supports block mode (most new drives do), select Enabled for automatic
detection of the optimal number of block read/writes per sector the drive can support. The
settings are: Disabled, Enabled (default).
PATA DMA Mode
Force IDE device to work in DMA33 or DMA66/100 mode.
Auto ( Default ) By system determine automatically.
DMA33 Work in DMA 33 mode.
DMA66/100 Work in DMA 66/100 mode.
Note: That is supported fastest speed by IDE device to determine in DMA66 or DMA100.
4-7-1 OnChip IDE Device Function
Phoenix-AwardBIOS CMOS Setup Utility
OnChip IDE Device
Item Help
On-Chip Primary PCI IDE
On-Chip Serial ATA [Enhanced Mode]
SATA PORT Speed Setting Disabled
PATA IDE Mode Secondary
SATA Port P0,P2 is Primary
*** On-Chip Serial ATA Setting ***
[
Enabled]
PATA DMA Mode [
Auto]
IDE DMA transfer access
Disabled]
IDE HDD Block Mode [
Enabled]
IDE Primary Master PIO [Auto]
IDE Primary Slave PIO [Auto]
IDE Primary Master UDMA [Auto]
IDE Primary Slave UDMA [Auto]
On-Chip Secondary PCI IDE [Enabled]
IDE Secondary Master PIO [Auto]
IDE Secondary Slave PIO [Auto]
IDE Secondary Master UDMA [Auto]
IDE Secondary Slave UDMA [Auto]
Menu Level
↑↓→←
:Move Enter:Select +/
-
/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6: Fail-Safe Defaults F7:Optimized Defaults
[
USB Device Setting
Please refer to section
COM 3 422/485 flow control
This item allows you to disable or enable RS422 or RS485 function on COM 3, if you need.
X