Quick Start Guide User Manual

ManualsBrandsB&B Electronics ManualsAccessories communicationGW-7472

English/ Dec 2010/ Version 1.0

For GW-7472

GW-7472

The package includes the following items:

EtherNet/IP to Modbus RTU GatewayEtherNet/IP to Modbus RTU Gateway

What’s in the shipping

package?

Software CD

CA-002

(DC connector to

2-wire power cable)

Quick Start Guide

(

This Document

)

Installing software on your PC

Install GW-7472 Utility:

The software is located at:

Fieldbus_CD:\EtherNetIP\Gateway\GW-7472\Utility

http://ftp.icpdas.com/pub/cd/fieldbus_cd/ethernetip/gateway/gw-7472/utility/

GW-7472

Quick Start Guide

Summary of content (6 pages)

PAGE 1
For GW-7472 English/ Dec 2010/ Version 1.0 EtherNet/IP to Modbus RTU Gateway What’s in the shipping package? The package includes the following items: GW-7472 Software CD Quick Start Guide (This Document) CA-002 (DC connector to 2-wire power cable) Installing software on your PC Install GW-7472 Utility: The software is located at: Fieldbus_CD:\EtherNetIP\Gateway\GW-7472\Utility http://ftp.icpdas.
PAGE 2
Connecting the Power and Host PC 1. Make sure your PC has workable network settings. 2. Disable or well configure your Windows firewall and anti-virus firewall first, else the “Network Scan” on step 4, 5 and 6 may not work. (Please contact with your system Administrator) 3. Check Init/Run DIP switch if it is on Init position. EtherNet/IP to Modbus RTU Gateway 4. Connect both the GW-7472 and your computer to the same sub network or the same Ethernet switch, and power the GW7472 on.
PAGE 3
EtherNet/IP to Modbus RTU Gateway Searching the GW-7472 1. Double click the GW-7472 Utility shortcut on the desktop. 2. Click the “Network Scan” button to search your GW-7472. 3.
PAGE 4
Module configuration 1. 2. 3. 4. Double click the GW-7472 Utility shortcut on the desktop. Click the “Network Scan” button to search your GW-7472. Select “Configure” buttons to configure the module After setting, click the “Update Settings” button to finish the configuration. EtherNet/IP to Modbus RTU Gateway Item Settings (Init Mode) IP 192.168.255.1 Gateway 192.168.0.1 Mask 255.255.0.
PAGE 5
Item Descriptions: Item Network Settings Port Settings Modbus Request Command Description For configuration of the Address Type, Static IP Address, Subnet Mask and Default Gateway of the GW-7472 Please refer to section “4.2.1 Network Settings” For configuration of the Baud Rate, Data Sizes, Parity, Stop Bits, of the RS-485/RS-422 port of the GW-7472 Please refer to section “4.2.2 Serial Port Settings” Modbus commands to communicate with the Modbus slaves Please refer to section “4.2.
PAGE 6
Item Descriptions: Item UCMM/Forward Open Class 3 Behavior Description Send UCMM packets or use the Forward_Open service to build the CIP class 3 connection to communicate with the GW-7472. Please refer to section “4.3.1 UCMM/Forward Open Class 3 Behavior” Forward Open Class1 Behavior Use the Forward_Open service to build the CIP class 1 connection to communicate with the GW-7472. Please refer to section “4.3.