Specifications

Page 19

The V-Smart shall support an unlimited number of users since the fingerprint

template file is stored on the smart card itself rather than on the V-Smart

reader’s internal memory. A maximum of two fingerprint templates may be

stored per contactless smart card.

9.2. Supported Cards

The V-Smart shall support the following MIFARE contactless smart cards:

 Gemplus GemEasy 8000 (1 kByte memory)

 HID Corp. HID 1430* (1 kByte memory)

 HID Corp. HID 1431** (1 kByte memory)

 IDentiSMART Series by IDenticard (1 kByte memory)

The V-Smart reader may also support other cards. Please contact Bioscrypt

Technical Support to confirm card compatibility.

*Order HID cards non-programmed.

**Order HID cards programmed only for 125 kHz or entirely non-programmed.

9.3. Memory

The V-Smart reader shall utilize non-volatile flash memory to store all data

configurations and shall therefore not lose any configuration information if the

reader is powered down.

9.4. SiteKey

The SiteKey shall be a password used by the V-Smart, the smart cards, and

the VeriAdmin software to communicate and transfer information. If the

SiteKey stored in the V-Smart does not match the SiteKey stored in the smart

card, the V-Smart will be unable to read or write to the card. This key shall

ensure that only authorized smart cards are used at a specific installation.

Additionally, the SiteKey shall act as the administrator password so that only

authorized personnel may perform read/write functions on the V-Smart, such

as enrollments, deletions, and V-Smart security configuration.

By default, each V-Smart reader shall contain an empty-string for the SiteKey

that should be configured prior to enrollment. Each installation must set their

own SiteKey to distinguish their V-Smart contactless smart cards from every

other V-Smart installation. The SiteKey shall be stored within the internal

memory of the V-Smart and shall be encrypted and stored on the smart card