User Manual

Driver Software Installation
Manual Documentation Number 3PCIoUx-1008 Chapter 3 39
8. In the Advanced Settings dialog set the Receive buffer: Low,
Transmit buffer: Low, RTS Control and Hardware handshaking
Hysteresis level (characters)
as necessary.
Note: For more information on advanced settings refer to Chapter 4
Figure 29. The Advanced Port Setting Dialog
9. Click OK to return to the Communications Port Settings.
10. Click
Cancel to return to the Assign Ports dialog.
11. Repeat the procedure for any additional ports on the list.
12. Re-start your computer so the changes will take effect.
Note: After restarting the computer, you can check the Ports applet to
make sure that the driver assigned the COMx names to the serial
ports; however, you must not change the settings of the serial port
within the Ports applet.