Specifications

232XSSD43800 Manual 21
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH [phone] -- FAX [phone]
Selecting Ports
To select a port the user need only pick from the Menu->
Comport the comport to which the device is attached. The Smart
Switch program supports comports 1 through 6. If the port exists but
does not have a smart switch device attached, SS will not detect it.
The SS software will only detect invalid/undefined comports.
Parameters
The Port Address is the address where the serial
communications port is located. If this is unknown you can use the
program PORTFIND.EXE which is located on the disk. To use
PORTFIND.EXE:
If you installed the software on your hard drive (see the
Installation section):
•
Type
C:
and press the
ENTER
key.
•
Type
CD\SS\UTIL
and press the
ENTER
key.
•
Type
PORTFIND
and press the
ENTER
key.
Uninstalling Windows Smart Switch Selector Program
•
Go to “Control Panel” and click on “Add/Remove Programs”
•
Click on “Smart Switch” and the click “Remove”
•
Windows will then “Automatically” remove the program from
your system
DOS TSR Installation and Instructions
The software for the XSSTSR can be run from a floppy drive or
from the hard drive.
There are two methods to begin the XSSTSR program. The first
and preferred way is to use the SETUP.EXE program and the
second is through the XSSTSR.COM file.