Installation manual

Rev. B 4 KEMU000826
03/26/04
SECTION 3:
CONFIGURING THE AVBPITPOS
3.1 DIP SWITCHES
The AVBPIT1 is designed to interface different POS devices with the Rapid Eye system.
The POS device and its related serial communication parameters are selected using
three banks of DIP switches (S1, S2 and S3), which are found under the removable lid.
Access the DIP switches by removing the lid as shown in Figure 4.
1. Unscrew the 2 screws used to secure the lid to the AVBPIT1 housing.
2. Retain the screws for use when replacing the lid later in the installation
procedure.
S1
S2
S3
Figure 4: Accessing DIP Switches