Installation manual

Rev. B 12 KEMU000826
03/26/04
4.1 SETTING UP RAPID EYE SOFTWARE, CONTINUED
10. After System Operational feedback is received, test the communication
between the AVBPITPOS and Rapid Eye by toggling DIP switch (S1) position 8
ON and OFF. Data window should display similar result as shown in the
Panasonic window below.
11. You can further customize the configuration by setting up the Rules to create
Log and Alarm events based on the data being captured by the Rapid Eye
system. If Rules are not required, skip to Step 14.
12. Create rules for data events by entering the appropriate information in the Event
Name and Event Rule dialogue boxes then clicking the Add button. The Event
Name will appear in the Events window. Consult Rapid Eye’s VIEW user Guide
for more information about this capability.