Technical data

Purging ◆ Using Color 0
310633C 45
Using Color 0
1. Press Standby on the Operator Station.
2.
3. If using a gun flush box, place the gun into the box.
4. Select Color 0 and press Enter .
5. If a gun flush box is not used, trigger
the gun into a grounded metal pail
until the purge sequence is com-
plete.
6. The color change LED blinks while Color 0 runs
and turns solid after purge sequence is complete.
If the system is not completely clean, you can
repeat Color 0 by pressing
.
Color 0 is typically used:
• in multiple color systems to purge out material lines
without loading a new color
• at the end of a shift to prevent hardening of cata-
lyzed material.
To setup Color 0, see page 32.
Operator Station Screen
LED
WARNING
If using an electrostatic gun with a gun flush box, shut
off the electrostatics before placing the gun in the box.
page 24