Technical data

Installation ◆ Cable Connections

310633C 21

4. Route the opposite Fiber Optic Cable end through

the Smart Fluid Panel strain relief connector

(D). FIG. 15. Do not route the cable with tight bends

or kinks.

5. Connect the blue and black cable connectors (E) to

the matching connectors on the electrical circuit

board. F

IG. 16. Insert the cable connectors until

they bottom out (approximately ¼” [6 mm]), then

tighten the threaded connector.

6. Tighten the strain relief connector (D). FIG.

16.

Connect Operator Station to

Smart Fluid Panel

The Operator Station cable (F) is factory wired into the

Operator Station. F

IG. 17. Do not disconnect the cable

except to replace it. Route the 50 ft. (15.2 m) cable to

the Smart Fluid Panel and connect it to the Operator

Station connector

(G). FIG. 15.

Gun Flush Box

Refer to the Gun Flush Box manual for installation and

connection instructions.

Printer

If using a printer, plug the printer cable into the

EasyKey™ Display connector

(H).

The fiber optic cable has a minimum bend radius of

1.6 in. (40 mm).

IG. 15

CAUTION

Do not over-tighten or cause excessive stress on the

circuit board connector.

IG. 16

E D

FIG. 17

IG. 18