User's Manual

3 LED and Reset button behavior

Power LED: It is always on after power on.

Link LED behavior:

LED is OFF. The module is not powered, has not yet started, or is in Power Save mode if

power LED is on.

LED is blinking slowly. The module has started but has not yet associated with any network.

LED is blinking fast. The module is attached to a network but is disconnected (or not yet

connected), meaning no video connections are currently processed.

LED is ON. The module is hosting an ongoing audio video connection with a station in the

network.

TX Transmitter module Reset Button:

When the module is ON:

Short press(1 second): NEXT-WVAN. This function allows users to switch the current

association over to the next available network. This disconnects the current connection and

triggers a channel scan and association to the next available coordinator. Each time the signal

goes LOW, the radio switches to the next network in order of channel priority, when available,

until the transmitter module is re-associated with its first network.

Long press(5 seconds): RESET to FACTORY. This function allows users to reset the

transmitter module to its original shipping condition. All run time settings are erased from

memory. The main use of this function is to set the current channel setting to factory default,

which is LR2 HR2.

RX Receiver module Reset Button:

When the module is ON:

Short press(1 second): NEXT-SOURCE.This function allows users to switch the source of the

audio/video to another WirelessHD transmitter in range. This disconnects the current video

connection and triggers a connection to the next source available in the current network

device list. Each time the signal goes LOW, the audio/video source switches to the next video

source, until the receiver module is reconnected to its original audio/video source. If there is

only one WirelessHD audio/video source transmitter in range, the short press will not have

any effect because there is no video source to switch to.

Long press(5 seconds): RESET to FACTORY. This function allows users to reset the receiver

module to its original shipping condition. All run time settings are erased from memory. The

main use of this function is to set the current channel setting to factory default, which is LR2

HR2.