WirelessHD Tx/RX Module User’s Manual
FCC Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment. USERS MANUAL OF THE END PRODUCT: In the users manual of the end product, the end user has to be informed to keep at least 20cm separation with the antenna while this end product is installed and operated. The end user has to be informed that the FCC radio-frequency exposure guidelines for an uncontrolled environment can be satisfied.
IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. IMPORTANT NOTE: This module is intended for OEM integrator. The OEM integrator is still responsible for the IC compliance requirement of the end product, which integrates this module.
Index 1 Introduction ...................................................................................................................... 1 1.1 Product Layout ........................................................................................................ 1 1.2 1.3 1.4 Features ..................................................................................................................... 1 Package Content ..................................................................................
1 Introduction AW-WH036T and AW-WH036R is a whole set of WirelessHD products. They can stream uncompressed audio and video up Full HD (FHD) resolution. It works at 60GHz band which is available on an unlicensed basis in many regulatory domains with a typical range of 10 meter. AW-WH036T and AW-WH036R replaces the HDMI cable and simplifies home theater system installation. The source devices, such as BD player or Set Top Box, don’t need to be located near to the TV. 1.
Latency: <1ms Video Resolution: Up to 1920 X 1080 Progressive (1080P) ~ 8 Channels Audio (32 ~ 192KHz) Array Antenna HDMI 1.3 Compatible DTCP (Digital Transmission Content Protection):AES-128 CTR mode HDCP 2.0 Support 1.3 Package Content The package include the below package content: One set of AW-WH029T and AW-WH029R Power Adapter User’s Manual 1.
Connector Micro USB Connector Display Resolution Support 480p/60Hz to 1080p/60Hz Video Format RGB: 4:4:4 YCbCr: 4:4:4 Audio Channel 2~8 Sample Rate 32-192kHz RF Specifications Frequency Range Modulation Occupied Bandwidth Output Power Receive Sensitivity Data Rates 57~66GHz HRP: OFDM with QPSK , 16-QAM LRP: OFDM with BPSK HRP:1.76Ghz LRP: 92Mhz HRP: TBD LRP: TBD HRP: TBD LRP: TBD HRP: Up to 3.807 Gb/s LRP: Omni-directional mode Up to 10.
2. Connect the power adapter to the WirelessHD product and power outlet. 3. Connect HDMI connector on AW-WH036T to media source such as BD Player and connect HDMI connector on AW-WH036R to flat panel display such as LCD TV by HDMI cable. 4. Turn on power switch. 5. After 10 ~ 30 seconds, it will do auto-connection. If LCD TV shows display, that means that the products begin working. 3 Important Notice The Power adapter must be 5A / 2A.
