= Azure Wave WWW reweave com 5. Double Click “Create Connection” and put BD address of the slave device into the BADDER box. Click “OK” 6. In the “HCI Control” window,select”0 Vendor-specific commands”. Double Click "Update ART Baud Rate”. Select then click OK. A connection should establish now. This can be verified by looking in the log windows for both devices, which should now contain Connection Complete events with “Success” in the status field.
WWW reweave com = Azure Wave RF Performance Test The following procedure explains how to configure the AW-NM230NF-H for RF testing using Broad com Blue Tool. At the completion of the procedure, connect the Bluetooth test instrument to the AW-NM230NF-H with RF cable and performs the RF tests. RESETTING THE USB DEVICE To reset the USB device on HCI Central, in the HCI Control commands list, select 7.3: Hast Controller & Base band Commands {3 key), and then double-click Reset.
WWW reweave com = Azure Wave To enable Test Mode © In HCI Control, in the HCI Control commands list, select 7.6: Testing Commands (6 key}, and then double-click Enable_Device_Under_Test_Mode. The AW-NM230NF-H is now ready to receive a connection request from the Bluetooth tester and begin testing specified RF parameters. 3.
WWW reweave com = Azure Wave This device is intended only for OEM integrator under the following conditions: 1) The antenna must be installed such that 20 em is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, 3) For all products market in US, OEM has to limit the operation channels in CH1 to CH for 2.4G band by supplied firmware programming tool.
= Azure Wave Brainwave Technologies, ne. WWW. gzurewove.com 4, Pin Definition / Pin Map No Connect Floating No Connect Floating No Connect Floating 3.3V power pin vee 3.3V power pin vee Ground. GND No Connect Floating No Connect Floating No Connect Floating No Connect Floating GPO pin 0 GPO pint Io NC No Connect Floating NC No Connect Floating NC No Connect Floating NC No Connect Floating Ground. GND NC No Connect Floating NC No Connect Floating Ground.
= Azure Wave Brainwave Technologies, ne. WWW. gzurewove.com section in reset. This pin has an internal 200k ohm pull down resistor that is enabled by default. It can be disabled through programming.
= Azure Wave Brainwave Technologies, ne. WWW. gzurewove.com 54 ART CTS High-Speed ART CTS I 33 55 ART OUT High-Speed ART Data Out 0 3av 56 ART IN High-Speed ART Data In I 33v 57 ART RIS High-Speed ART RTS a 33v 58 PCM SYNC PCM Synchronization control 0 vy 59 PCM IN PCM data Input 1 33v 60 PCM OUT PCM data Out 0 33v 61 PCM CLK PCM Clock 1/0 33v 62 GND Ground GND Used by PMU to power up or power down the internal regulators used by the Bluetooth section.
